Weathervane Setup Instructions

1. Decide on a suitable open and prominent position to locate
    your weathervane.

2. Open up the N.S.E.W. and push the Lock Washer down into
    position to form the cross.

3. Use a spirit level to ensure that the support stem is straight and
    upright. Now Screw the bottom plate of the stem firmly to your
    fixture using non corrosive screws or bolts.

4. Slide on the NSEW to rest on the support stem. Use a
    compass to find north, aim to the correct position and firmly
    tighten off the lock screw.

5. Before sliding on the top section, apply some grease to the
    axle. Important: The ball bearing must slide up inside the axle
    to rest on top of the shaft, this will reduce wear and ensure
    smooth movement.